Replication in R
R code that regenerates the numbers this paper reports, starting from the dataset published on this site. It reproduces 27 of 28. The one that does not match is listed below.
Run it
Rscript run.R
run.R is the whole package. Save it and run it: it reads the dataset from
this site if the CSV is not sitting beside it, and loads the shared conventions file the same way,
so it works on its own in an empty directory. It needs R with fixest, and depending on
the paper lme4, metafor, plm, BMS or
LowRankQP. It writes results.json, one value per number, each named for
where it appears in the paper.
How it compares with Stata
Most of these papers were estimated in Stata, and the two programs differ in places that change
printed digits. Those conventions are stated once, in
stata_compat.R, and shared by every replication on this site:
ivreg2's large-sample variance, SSC winsor's order statistics,
xtreg's treatment of singleton groups, and the restricted-ML default of
xtmixed, which is not the default of the mixed command that replaced it.
Numbers that do not match the printed paper
Cells are named as they are in results.json. The reason for each difference follows the table.
| cell | paper | this code |
|---|---|---|
| T2_PanelC_WAAP_se | 0.013 | 0.013573 |
The printed figure is exactly this package's value cut off at the printed precision rather than rounded to it: rounded it would end in a different digit. The other numbers in the same table round normally, so this is not a convention of the paper but a transcription that looks hand-copied. Everything else in the table reproduces. The printed value is left exactly as published.
Files
- run.R, the replication
- stata_compat.R, the Stata conventions
- targets.json, the numbers as printed in the paper, taken from the paper rather than from the code
- results.json, the numbers this code produced
- REPLICATION_STATUS.md, the full comparison, generated from this package's own output